04-17-2012, 10:23 PM
Ok, since I am editing a load of tilesets at the moment using this, I figured I'd show you all how I did it. It's very simple, but rather effective. Oh and I'm not a spriter either, so if I can do it, anyone can. Note that I use Paint.net software, so it will likely be a different layout from whatever you people use, but I'm relatively sure the basic elements are still there.
So! Here's the tutorial;
So! Here's the tutorial;
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
And here's a little example. This is the Interior_B tileset from VX Ace that I edited. All the blood done on this tileset was created using the same method I showed above;