AnimBat! - Animated Battlers - Comprehensive
08-20-2014, 12:11 AM
Hello again,
I am trying to configure a characterset in the animated battlers section of the script, as the character sheet I am using is also in my battlers folder and I would like to see the animated battler in my party. only problem is, the sprite seems to be cut off. The animations are occurring somewhat, with the front and back of the full animation seemingly clipped from the picture. the dimensions of the character set are exactly the same as Charlie's CTB demo custom spritesheets (even with 11 poses with 4 frames each, dimensions: 256 x 704) i maid sure to pay close attn to the MNK_POSES_ACTOR values in the Animation Frames and Animation Speed array as well as the Individual Spritesheet Control Center section.
In the attached picture, I am using the base of a sprite that will temporarily stand in for my inevitable finished sprite, and it is captured here in mid-animation, but not in its complete form. What resizing needs to be done, or what value in the configuration page should be adjusted to suit this base sprite (also attached).
thanks,
bswi
I am trying to configure a characterset in the animated battlers section of the script, as the character sheet I am using is also in my battlers folder and I would like to see the animated battler in my party. only problem is, the sprite seems to be cut off. The animations are occurring somewhat, with the front and back of the full animation seemingly clipped from the picture. the dimensions of the character set are exactly the same as Charlie's CTB demo custom spritesheets (even with 11 poses with 4 frames each, dimensions: 256 x 704) i maid sure to pay close attn to the MNK_POSES_ACTOR values in the Animation Frames and Animation Speed array as well as the Individual Spritesheet Control Center section.
In the attached picture, I am using the base of a sprite that will temporarily stand in for my inevitable finished sprite, and it is captured here in mid-animation, but not in its complete form. What resizing needs to be done, or what value in the configuration page should be adjusted to suit this base sprite (also attached).
thanks,
bswi
